Machinability Analysis of Delamination and Thrust Force in Drilling of Pure and Added Gfrp Composites

Abstract

The effects of cutting parameters on the thrust force and delamination factor in the drilling of pure, Al2O3, and SiO2 added GFRP/epoxy composites were investigated. Experimental studies were performed to investigate thrust force and delamination factor. Taguchi experimental design and response surface methodology were employed to establish parametric relationships between the experimental parameters and the machinability outputs consisting of delamination and thrust force. When examining the effect of cutting speed and feed on thrust forces and delamination factors for the three materials, the smallest values of the cutting parameters for all three materials gave the minimum thrust forces and delamination factors. Machinability Index is also proposed. According to the machinability index, under the effect of delamination and thrust force parameters, it was seen that pure epoxy composite material has better machinability than the other composite materials. It has been found that the effect of feed rate on delamination is greater than the cutting speed, and the cutting speed has a low effect.