Browsing by Author "Al-Okla, Mudar"

Now showing 1 - 2 of 2

Coprecipitation Method for Preparing Cobalt Oxide (Co3O4) Catalyst to Efficiently Oxidize Ammonia
(Pleiades Publishing Ltd, 2025) Al-Okla, Mudar; Zeidan, Hani
In this study three samples of cobalt oxide were prepared via coprecipitation at pH 9.5 using cobalt nitrate as a precursor. They were dried at 120 degrees C before calcining at 400, 500, and 600 degrees C. The crystalline phases were determined using X-ray diffraction (XRD), revealing the presence of the Co3O4 phase in all prepared samples in varying proportions. Fourier Transform Infrared Spectroscopy (FTIR) spectra showed distinct bands corresponding to the vibrational motion of the Co-O bond, confirming the formation of cobalt oxide (Co3O4). Scanning electron microscope (SEM) analysis of the Co 500 sample revealed particles in the range of 40-350 nm (average similar to 100 nm) with relatively low agglomeration, while energy-dispersive X-ray spectroscopy (EDX) confirmed a composition consistent with stoichiometric Co3O4 (85.7 wt % Co and 13.6 wt % O). Pyridine-adsorbed FTIR spectra indicated that the sample calcined at 500 degrees C possessed the most balanced ratio of Lewis and Br empty set nsted acid sites, which correlated with its highest catalytic activity. The textural properties of all samples were analyzed using nitrogen adsorption data at 77 K, and the adsorption isotherms were found to be type IV, with hysteresis loops indicating capillary condensation in mesopores. The specific surface area reached a maximum of 4.837 m(2)/g for the sample calcined at 500 degrees C. This sample also exhibited the highest total acidity (0.035 mmol/g) and strong acidic sites (the initial electrode potential value E-i = 73.2 mV), which enhanced catalytic performance. Pore radius calculations further revealed that the samples contained mesopores. The catalytic efficiency of the prepared samples in the ammonia oxidation reaction was evaluated at 450 degrees C. The sample calcined at 500 degrees C demonstrated the highest catalytic activity. The sample calcined at 500 degrees C achieved 100% NH3 conversion at 475 degrees C and maintained full activity over 10 consecutive cycles, demonstrating high stability and reusability.
Citation - Scopus: 1
Impact of Temperature on the Structural and Optical Properties of Silver Sulfide Films Prepared by Chemical Bath Deposition
(Pleiades Publishing Inc, 2024) Tukko, Muhammad Nor; Al-hajji, Muhammad Ali; Alasle, Sulyman; Al-Okla, Mudar; Zeidan, Hani
Transparent semiconducting silver sulfide (Ag2S) thin films were deposited by chemical bath deposition technique on glass substrates. The effect of different deposition temperatures (10, 20, and 30 degrees C) on the structural and optical properties of silver sulfide films was studied. The XRD spectra showed that the structure of the films was monoclinic and polycrystalline, and the predominant growth of crystals was at the plane (022). The intensity of the peaks increases with increasing preparation temperature, becoming narrower and clearer. The best-structured films with the least crystalline defects were that prepared at 30 degrees C. UV-VIS spectroscopic scanning showed that all films had a minimum transmittance and maximum absorbance at the ultraviolet field within the range 300-350 nm. The transmittance decreased and absorbance increased with increasing wavelength and temperature. The energy gap values changed within the range 2.105-2.242 eV, which clearly increased with increasing preparation temperature.