Ünal, AlptuğUğur, Ahmet Emin2022-05-232022-05-2320222352-0124https://doi.org/10.1016/j.istruc.2022.02.051https://hdl.handle.net/20.500.13091/2438This study was carried out to investigate the effect of polypropylene-based structural macro synthetic fiber (PPF) reinforcement on the behavior of reinforced concrete beams produced with self-compacting concrete (SCC). For this purpose, it was aimed to spread the PPFs homogeneously in the concrete by making use of the fluid form of SCC. The variation of non-fibrous-low-medium-high PPF ratios and stirrup ratios in specimens produced with SCC are the variables of the study. In this study, the shear span/effective depth ratio (a/d) was taken as the limit value of 2.5 in terms of shear and bending, and the behavior of reinforced concrete beams at this critical value was investigated. Within the scope of the study, 16 large-scale specimens were tested under monotonic loads in a 4-point bending setup. Load-displacement, stiffness and energy consumption graphs of the tested specimens were drawn, ductility values were determined, crack distributions were examined and failure modes were determined. The graphs and the determined values were interpreted in detail. In addition, numerical models of the tested specimens were created and analyzed using a finite element program. Experimental study results were compatible with numerical analysis results and similar results were obtained. According to the results obtained, it was observed that the specimens produced with SCC and using PPF reinforcements at appropriate ratios (5 kg/ m3 and 10 kg/m3) exhibited bending failure even if stirrups were not used.eninfo:eu-repo/semantics/closedAccessPolypropylene fibersSelf-compacting concreteWith and without stirrupShear and bending strengthExperimental studyFinite-element analysisEffective-Depth RatioFlexural BehaviorLightweight ConcreteShear BehaviorSteelStrengthGlassArticle10.1016/j.istruc.2022.02.0512-s2.0-85125433040